PROTECT IT RIGHT
FROM THE START.
Your Tech Shield is precision-cut for your vehicle's screen. A clean surface, proper alignment, and a little patience are the keys to a flawless installation.
INSTALL IN A CLEAN ENVIRONMENT
Avoid wind, direct airflow, excessive dust, and direct sunlight.
YOUR INSTALLATION KIT INCLUDES
Prep Pad |
Suede Cloth |
Dust Stickers
Suction Cup |
Squeegee
IMPORTANT
Before removing any protective film, place your Tech Shield over the screen to confirm fit, orientation, and alignment.
WATER INSTALL INSTRUCTIONS
DRY INSTALL INSTRUCTIONS
CLEAN ENVIRONMENT
Install indoors whenever possible.
LIGHT WATER ONLY
A fine mist is all you need for water installation.
DON'T RUSH ALIGNMENT
Position the protector first, then squeegee.
WORK CENTER → OUT
Push water and air toward the nearest edge.
SEE MOISTURE OR SMALL AIR POCKETS?
Don't panic. Minor moisture, haze, or small pockets immediately following a water installation can be normal. Allow the protector time to settle and dry before attempting to lift or reposition it.
STOP BEFORE YOU REMOVE IT.
If your installation isn't going as expected, take a few clear photos and contact our support team. We may be able to help troubleshoot the installation before the product is removed.
Installation Disclaimer: Tech Shield products are precision-cut for the specific vehicle, model, year, and screen configuration selected. Always verify fit and orientation prior to installation. Installation results may vary based on environmental conditions, surface preparation, technique, and screen configuration. Do not cut, trim, or modify the product.